帮忙提提意见，冲浇口，单个产品重36克，进料口1.1厚17mm宽，

李张华 · 发表于 2022-4-20 14:33:20

浇口分型面开中间，前后模各开0.65mm

Manu · 发表于 2022-4-20 15:51:18

gate thickness too thin, increase thickness of ingate, Check cooling near the product wall.

15268679970 · 发表于 2022-4-21 07:23:23

浇口开厚点，增压别太大

Kaixing.Liao · 发表于 2022-4-22 08:52:04

浇口加厚，流道调整匀速进料，渣包引排气。

k84938943 · 发表于 2022-4-22 15:17:27

Manu 发表于 2022-4-20 15:51
gate thickness too thin, increase thickness of ingate, Check cooling near the product wall.

mold-design · 发表于 2022-4-24 17:02:46

Manu 发表于 2022-4-20 15:51
gate thickness too thin, increase thickness of ingate, Check cooling near the product wall.

Good, nice to meet you.

嘉科 · 发表于 2022-4-25 00:33:25

浇口上就应该缓冲

wcy4520 · 发表于 2022-4-27 08:24:02

Manu 发表于 2022-4-20 15:51
gate thickness too thin, increase thickness of ingate, Check cooling near the product wall.

谢谢指导

OCAN · 发表于 2022-4-30 21:14:35

开后一点，冲浇口的位置可以被覆

hello · 发表于 2022-7-30 17:02:53

进料那里开的那个是反冲吗，起什么作用的啊

		自动登录	找回密码
密码			立即注册

[求助] 帮忙提提意见，冲浇口，单个产品重36克，进料口1.1厚17mm宽，